I've been searching all throughout the internet for assistance, however there has been little to no solutions to my issue at hand. My project that im trying to get a gasp on is somewhat unique (UI is not exactly following the typical norms).
Below is a diagram of what i am trying to accomplish -- all within a UIView Controller:
Im sure experienced developers are fully aware of my issue, and or what im about to ask. I understand that a static UITableView is required to be in a tableview controller, but I need to display both the UItableView's at the same time which means it has to be within a UIView.
- UIView is the light grey background
- UITableView 1 - this is a static (or it can be dynamic, thats another challenge) UITableview which will hold different numeric values for calculation
- UITableView 2 - this is a UITableview which will hold calculated results every time it is run.
- UIImageView 1 - this is a calculated image example (I have that figured out)
I can make the interface look the way I need it to through the IB however when trying to compile and build I receive the error that requires the UITableView's to be within a UITableViewController and not a UIView Controller. I have seen many examples using a master-detail layout, but the only stipulation is that this UITableview NEEDS to be displayed 100% of the time when in this view.
So basically, I am asking for direction... but a code example never hurt either! Thank you 100x's over!